Hyundai Sonata: Antenna. Repair procedures
Inspection
1. |
Wrap aluminum foil (A) around the tip of the tester probe (B)
as shown.
|
2. |
Touch one tester probe to the glass antenna terminal (A) and move
the other tester probe along the antenna wires to check that continuity
exists.
|
To make an effective repair, the broken section must be no longer
than one inch.
|
1. |
Lightly rub the area around the broken section (A) with fine steel
wool, and then clean it with alcohol.
|
2. |
Carefully mask above and below the broken portion of the glass
antenna wire (B) with cellophane tape (C).
|
3. |
Using a small brush, apply a heavy coat of silver conductive paint
(A) extending about 1/8″on both sides of the break. Allow 30 minutes
to dry.
|
4. |
Check for continuity in the repaired wire.
|
5. |
Apply a second coat of paint in the same way. Let it dry three
hours before removing the tape.
|
1. |
Remove the right side rear quarter trim.
Then disconnect the antenna feeder cable (A) from the glass antenna
amp.
|
2. |
Turn the radio ON.
Measure the voltage between terminal 2 of the harness side feeder
cable (A) and body ground (B).
|
3. |
Check for FM wire resistance between terminals of No.1 and 3
1. FM antenna grid terminal
2. AM antenna grid terminal
3. Body ground.
|
4. |
Check for AM wire resistance between terminals of No.2 and 3.
|
5. |
Check the grid lines for continuity.
|
6. |
When a poor radio reception is not repaired through the above
inspection methods, replace the amp.
If the radio reception is still poor, check the radio cable for
short and radio head unit for failure.
|
1. |
Remove the antenna jack (A) from the audio unit and antenna.
|
2. |
Check for continuity between the center poles of antenna cable.
|
3. |
Check for continuity between the outer poles of antenna cable.
There should be continuity.
|
4. |
If there is no continuity, replace the antenna cable.
|
5. |
Check for continuity between the center pole of antenna cable
and terminal of glass antenna. There should be continuity.
|
6. |
If there is no continuity, replace the antenna amplifier.
|
7. |
Check for continuity between the center pole (A) and outer pole
(B) of antenna cable. There should be no continuity.
|
8. |
If there is continuity, replace the antenna cable.
|
Speakers. Repair procedures
Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that ...Audio Remote Control. Schematic Diagrams
Circuit Diagram ...See also:
How to use this manual
We want to help you get the greatest possible driving pleasure from your vehicle.
Your Owner’s Manual can assist you in many ways. We strongly recommend that you
read the entire manual. In order ...
Tire and loading information label
The label located on the driver's door sill gives the original tire size, cold
tire pressures recommended for your vehicle, the number of people that can be in
your vehicle and veh ...
General Information
The Micro 570 Analyzer
The Micro 570 Analyzer provides the ability to test the charging and starting
systems, including the battery, starter and alternator.
...