Inspection
1. |
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification:
Refer to “Wave Form”
|
|
Removal
•
|
DON’T remove the camshaft position sensor while the engine
is running or right after engine is turned off. The part and
engine oil is hot and can cause burns.
|
|
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the camshaft position sensor connector (A).
|
3. |
Remove the installation bolt (B), and then remove the sensor.
|
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the camshaft position sensor connector (A).
|
3. |
Remove the hanger and the protector.
|
4. |
Remove the installation bolt (B), and then remove the sensor.
|
Installation
•
|
Install the component with the specified torques.
|
•
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
•
|
Apply the engine oil to the O-ring.
|
|
•
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
•
|
Be careful not to damage the sensor housing and the connector.
|
•
|
Be careful not to damage the O-ring.
|
|
1. |
Installation is reverse of removal.
Camshaft position sensor installation
bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
Description
Knocking is a phenomenon characterized by undesirable vibration and noise
and can cause engine damage. Knock Sensor (KS) is installed on the cylinder
block and senses engine knoc ...
See also:
Sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof
with the sunroof control switch located on the overhead console.
The sunroof can only be opened, closed, or tilted ...
Windshield Glass. Repair procedures
Replacement
Removal
•
Put on gloves to protect your hands.
•
...
License plate light bulb replacement
1. Loosen the retaining screws with a philips head screwdriver.
2. Remove the soket by turning it connterclockwise.
3. Remove the bulb by pulling it straight out.
4. Install a new bulb.
5. Rei ...