Hyundai Sonata: Crankshaft Position Sensor (CKPS). Description and Operation
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and
is one of the most important sensors of the If there is no CKPS signal input,
the engine may stop because of CKPS signal missing. This sensor is installed
on the cylinder block or the transaxle housing and generates alternating current
by magnetic flux field which is made by the sensor and the target wheel when
engine runs.
The target wheel consists of 58 slots and 2 missing slots on 360 degrees
CA (Crank Angle).
Engine Coolant Temperature Sensor (ECTS). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Remove the ECTS (Refer to "Removal"). 3. After immers ...Crankshaft Position Sensor (CKPS). Troubleshooting
Wave Form ...See also:
Limitation of Active ECO operation
If the following conditions occur while Active ECO is operating, the system operation
is limited even though there is no change in the ECO indicator.
When the coolant temperature is low: The sys ...
Rear view camera
WARNING
This system is a supplementary function only. It is the responsibility of
the driver to always check the inside/outside rearview mirror and the area behind
the vehicle before ...
Repair procedures
Inspection
[System Inspection]
1.
Disconnect the vapor hose from the throttle body and connect a
vacuum pump to the nipple on the throttle body.
2 ...