Hyundai Sonata: Curtain Airbag (CAB) Module. Repair procedures - Airbag Module - RestraintHyundai Sonata: Curtain Airbag (CAB) Module. Repair procedures

Removal

1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the roof trim. (Refer to the Body group- Interior)
3.
Disconnect the curtain airbag harness connector.

4.
After loosening the mounting bolts and nuts remove the curtain airbag.


Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Tighten the curtain airbag mounting bolts and nuts.

Tightening torque:
Bolts : 9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)
Nuts : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

•
Never twist the airbag module during installation. If the airbag module is twisted, it may not operate as designed.
4.
Connect the curtain airbag connector.
5.
Install the roof trim. (Refer to the Body group- Interior)
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

    Airbag Module Disposal. Description and Operation
    Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those installed in vehicle to be scrapped), the airb ...

    See also:

    Power windows
    The ignition switch must be in the ON position for power windows to operate. Each door has a power window switch that controls the door's window. The driver has a power window lock switch whic ...

    Trunk Trim. Repair procedures
    Replacement • Put on gloves to protect your hands. • ...

    Engine Control Module (ECM). Repair procedures
    Removal When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. ...