Hyundai Sonata: CVVT Oil Control Valve (OCV). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Sonata: CVVT Oil Control Valve (OCV). Repair procedures

Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the CVVT oil control valve connector (A).
3.
Remove the installation bolt (B), and then remove the valve from the engine.
[Bank 1 / Intake]

[Bank 1 / Exhaust]

Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Apply engine oil to the valve O-ring.
1.
Installation is reverse of removal.
CVVT oil control valve installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Variable Intake Solenoid (VIS) Valve. Description and Operation
    Description Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ...

    See also:

    Multimedia jack. Schematic Diagrams
    Circuit Diagram ...

    Immobilizer Control Unit. Repair procedures
    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash ...

    Manual climate control system
    Type A Type B 1. Front windshield defrost button 2. Rear window defroster button 3. Fan speed control knob 4. Mode indicator 5. Mode selection button 6. Air intake control button 7. Air co ...