Hyundai Sonata: ETC (Electronic Throttle Control) System. Description and Operation
Description
The Electronic Throttle Control (ETC) System consists of a throttle body
with an integrated control motor and throttle position sensor (TPS). Instead
of the traditional throttle cable, an Accelerator Position Sensor (APS) is used
to receive driver input. The ECM uses the APS signal to calculate the target
throttle angle; the position of the throttle is then adjusted via ECM control
of the ETC motor. The TPS signal is used to provide feedback regarding throttle
position to the ECM. Using ETC, precise control over throttle position is possible;
the need for external cruise control modules/cables is eliminated.
Schematic Diagram
Engine Control Module (ECM). Repair procedures
Removal When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. ...ETC (Electronic Throttle Control) System. Troubleshooting
Fail-Safe Mode Item Fail-Safe ETC Motor Throttle valve stuck at 5В° TPS TPS 1 fault ECM looks at TPS2 ...See also:
Wheel. Repair procedures
Hub nut tightening sequence
Tighten the hub nuts as follows.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...
Troubleshooting
Trouble Shooting
Ignition System
Symptom
Suspect area
Remedy
Engine will not start or is hard to start (Cranks OK)
Ignition lock switc ...
Seat Heater Switch. Repair procedures
Inspection
Front Seat Heater Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console upper cover (A).
...