Hyundai Sonata: ETC (Electronic Throttle Control) System. Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Sonata: ETC (Electronic Throttle Control) System. Repair procedures

Hyundai Sonata YF 2011-2014 Service Manual / Engine Control/Fuel System / Engine Control System / ETC (Electronic Throttle Control) System. Repair procedures

Inspection

Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Specification: Refer to “Specification”
3.
Turn the ignition switch OFF and disconnect the scantool from the DLC.
4.
Disconnect the ETC module connector and measure the resistance between the ETC module terminals 1 and 2.
Specification: Refer to “Specification”
ETC Motor
1.
Turn the ignition switch OFF.
2.
Disconnect the ETC module connector.
3.
Measure resistance between the ETC module terminals 3 and 6.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the resonator and the air intake hose (Refer to “Intake And Exhaust System” in EM group).
3.
Disconnect the ETC module connector (A).
4.
Disconnect the coolant hoses (B).
5.
Remove the installation bolts (C), and then remove the ETC module from the engine.

Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.
Electronic throttle body Installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Manifold Absolute Pressure Sensor (MAPS). Description and Operation
    Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog ...

    See also:

    Description and Operation
    Cruise Control The cruise control system is engaged by the cruise "ON/OFF" main switch located on right of steering wheel column. The system has the capability to cruise, coast, ac ...

    Multimedia jack. Repair procedures
    Removal 1. Remove the shift lever knob. (Refer to the BD group - "Console") 2. Remove the console upper cover (A). ...

    Light bulbs
    WARNING - Working on the lights Prior to working on the light, firmly apply the parking brake, ensure that the ignition switch is turned to the LOCK position and turn off the lights to avoid sudd ...