Hyundai Sonata: Front Cross Member. Repair procedures - Revised
Replacement
1. |
Remove the front wheel & tire.
|
2. |
Loosen the bolt (A) and then disconnect the universal joint assembly
from the pinion of the steering gear box.
|
3. |
Remove the split pin and castle nut and then disconnect the tie-rod
end (A) from the front knuckle.
|
4. |
Loosen the bolt & nut and then remove the lower arm (A).
|
5. |
Disconnect the stabilizer link (B) with the front strut assembly
(A) after loosening the nut.
|
6. |
Loosen the bolt (A) & nut (B) and then remove the front roll stopper.
|
7. |
Loosen the rear roll stopper mounting bolts (A).
|
8. |
Disconnect the muffler rubber hanger (A).
|
9. |
Loosen the bolts & nuts and then remove the sub frame.
|
10. |
Remove the front lower arm.
(Refer to the Front lower arm)
|
11. |
Remove the front stabilizer.
(Refer to the Front stabilizer)
|
12. |
Remove the steering gearbox.
(Refer to the ST group - 'steering gearbox')
|
13. |
Installation is the reverse of removal.
|
14. |
Check the alignment.
(Refer to 'Tires/Wheels - alingment')
|
Replacement
1. |
Remove the front wheel & tire.
|
2. |
Loosen the bolt (A) and then disconnect the universal joint assembly
from the pinion of the steering gear box.
|
3. |
Remove the split pin and castle nut and then disconnect the tie-rod
end (A) from the front knuckle.
|
4. |
Loosen the bolt & nut and then remove the lower arm (A).
|
5. |
Disconnect the stabilizer link (B) with the front strut assembly
(A) after loosening the nut.
|
6. |
Remove the under cover (A).
|
7. |
Loosen the rear roll stopper mounting bolts (A).
|
8. |
Disconnect the muffler rubber hanger (A).
|
9. |
Loosen the bolts & nuts and then remove the sub frame.
|
10. |
Remove the front lower arm.
(Refer to Front lower arm)
|
11. |
Remove the front stabilizer.
(Refer to Front stabilizer)
|
12. |
Remove the steering gearbox.
(Refer to ST group - 'steering gearbox')
|
13. |
Installation is the reverse of removal.
|
14. |
Check the alignment.
(Refer to 'Tires/Wheels - alingment')
|
Front Stabilizer Bar. Repair procedures - Revised
Replacement 1. Remove the front wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...See also:
How vehicle audio works
AM and FM radio signals are broadcast from transmitter towers located around
your city. They are intercepted by the radio antenna on your vehicle. This signal
is then received by the radio and s ...
Armed stage
Using the smart key
Park the vehicle and stop the engine. Arm the system as described below.
1.Turn off the engine.
2.Make sure that all doors, the engine hood and trunk lid are closed and latched. ...
Output Speed Sensor. Specifications
Specification
Item
Specification
Type
Hall Effect Sensor, 2pins
(Power: 9V, Signal)
Operation condition
-40 ...