Hyundai Sonata: Immobilizer Control Unit. Repair procedures
Replacement
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
|
3. |
Disconnect the 5P connector of the SMARTRA unit and then remove
the SMARTRA unit (A) after loosening the bolt.
|
4. |
Installation is the reverse of removal procedure.
|
Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner ...Antenna Coil. Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds after loosening the scr ...See also:
Manifold Absolute Pressure Sensor (MAPS). Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
...
Starting the engine
WARNING
Always wear appropriate shoes when operating your vehicle. Unsuitable shoes
(high heels, ski boots,etc.) may interfere with your ability to use the brake, accelerator
pedal, and clutch (i ...
Power Seat Control Switch. Schematic Diagrams
Circuit Diagram
...