Hyundai Sonata: Knock Sensor (KS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Sonata: Knock Sensor (KS). Repair procedures

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).
3.
Disconnect the injector connector (A).
4.
Remove the installation bolt (B), and then remove the sensor from the cylinder block.

Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.
Knock sensor installation bolt:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

    Heated Oxygen Sensor (HO2S). Description and Operation
    Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies ...

    See also:

    Seat Heater Switch. Schematic Diagrams
    Circuit Diagram ...

    Specifications
    Specifications Purge Control Solenoid Valve (PCSV) ▷ Specification Item Specification Coil Resistance (Ω) 19.0 ~ 22.0 [20°C( ...

    Turn by Turn
    The Turn by Turn feature can be used through Blue Link. 1. Direction Indicator Image 2. Remaining distance until next point 3. The Count bar is divided into a total of 9 levels. 4. Current Str ...