Hyundai Sonata: Lift And Support Points
When heavy rear components such as suspension, fuel
tank, spare tire, tailgate and trunk lid are to be removed, place additional
weight in the luggage area before hoisting. When substantial weight
is removed from the rear of the vehicle, the center of gravity may change
and can cause the vehicle to tip forward on the hoist.
|
|
1. |
Place the lift blocks under the support points as
shown in the illustration.
|
2. |
Raise the hoist a few inches (centimeters) and rock
the vehicle to be sure it is firmly supported.
|
3. |
Raise the hoist to full height to inspect the lift
points for secure support.
|
Using scissors lift
Using a scissors lift may cause damage of the side
out seal molding panel because the lift point is located higher than
side out seal molding panel.
Place wooden or rubber blocks (more than 50mm (1.9685in)
in height) between lift and vehicle lift point to prevent damage of
the side out seal molding panel.
|
Battery Caution Label Description
Warning / Caution Label (Cont'd) A. Keep lighted cigarettes and all other flames or sparks away from the battery. B. Wear eye protection ...Towing
If the vehicle needs to be towed, call a professional towing service. Never tow vehicle with just a rope or chain. It is very dangerous. Emergency Towing There are three popular method ...See also:
Camshaft Position Sensor (CMPS). Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification:
Refer to “Wave Form”
...
Airbag Module Disposal. Description and Operation
Airbag Disposal
Special tool required
Deployment tool 0957A-34100A
Before scrapping any airbags or side airbags (including those installed
in vehicle to be scrapped), the airb ...
Rear Wheel Speed Sensor. Repair procedures
Removal
1.
Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...