Hyundai Sonata: Manifold Absolute Pressure Sensor (MAPS). Repair procedures
Inspection
1. |
Connect the GDS on the Data Link Connector (DLC).
|
2. |
Measure the output voltage of the MAPS at idle and IG ON.
|
Removal
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the manifold absolute pressure sensor connector (A).
|
3. |
Remove the installation bolt (B), and then remove the sensor from
the surge tank.
|
Installation
|
|
1. |
Installation is reverse of removal.
|
Manifold Absolute Pressure Sensor (MAPS). Schematic Diagrams
Circuit Diagram ...Intake Air Temperature Sensor (IATS). Description and Operation
Description Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction o ...See also:
Electronic stability control (ESC)
The Electronic Stability control (ESC) system is designed to stabilize the vehicle
during cornering maneuvers. ESC checks where you are steering and where the vehicle
is actually going. ESC ap ...
Wiper blades
Blade inspection
✽ NOTICE
Commercial hot waxes applied by automatic car washes have been known to make
the windshield difficult to clean.
Contamination of either the windshield or the ...
Closing the trunk
To close the trunk, lower the trunk lid, then press down on it until it locks.
To be sure the trunk lid is securely fastened, always check by trying to pull it
up again.
WARNING
The trunk lid sh ...