Hyundai Sonata: Manual heating and air conditioning
The heating and cooling system can be controlled manually by pressing buttons or turning knob(s) other than the AUTO button. In this case, the system works sequentially according to the order of buttons or knob(s) selected.
1. Start the engine.
2. Set the mode to the desired position. For improving the effectiveness of heating and cooling;
- Heating:
- Cooling:
3. Set the temperature control to the desired position.
4. Set the air intake control to the outside (fresh) air position.
5. Set the fan speed control to the desired speed.
6. If air conditioning is desired, turn the air conditioning system on.
Press the AUTO button in order to convert to full automatic control of the system.
- Mode selection
- Temperature control
- Air intake control
- Air intake control
- Fan speed control
- Air conditioning
- OFF mode
Automatic heating and air conditioning
1. Press the AUTO button. The modes, fan speeds, air intake and air-conditioning will be controlled automatically according to the temperature setting. Type A Type B 2. Turn the tempe ...Mode selection
Type A The mode selection button controls the direction of the air flow through the ventilation system. The air flow outlet port is converted as follows: Refer to the illustration in the “M ...See also:
Components and Components Location
Components
1. Steering wheel
2. Steering column
3. ECU
4. Motor
5. Steering gear box
...
Room lamp
To turn the room lamp ON or OFF, push the switch or lens.
CAUTION
Do not leave the lamp switches on for an extended period of time when the
vehicle is not running. ...
Repair procedures
Starter Circuit Troubleshooting
The battery must be in good condition and fully charged.
1.
Discon ...