Hyundai Sonata: Master Cylinder. Repair procedures
Removal
1. |
Turm ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the air cleaner assembly (A).
|
3. |
Disconnect the brake fluid level switch connector (A), and vacuum
switch connector (B).
[2.4 GDI]
[2.0 T-GDI]
|
4. |
Remove the brake fluid from the master cylinder reservoir with
a syringe.
|
5. |
Disconnect the brake tube (A) from the master cylinder by loosening
the tube flare nut.
[2.4 GDI]
[2.0 T-GDI]
|
6. |
Remove the master cylinder (B) from the brake booster after loosening
the mounting nuts (A).
[2.4 GDI]
[2.0 T-GDI]
|
Installation
1. |
Installation is the reverse of removal.
|
2. |
After installation, bleed the (Refer to Brake system bleeding)
|
Master Cylinder. Components and Components Location
Components 1. Reservoir cap 2. Reservoir 3. Grommet 4. Master cylinder ...Brake Line. Components and Components Location
Components ...See also:
Operating door locks from inside the vehicle
With the door lock button
To unlock a door, push the door lock button (1) to the “Unlock” position.
The red mark (2) on the button will be visible.
To lock a door, push the door lock bu ...
Sunvisor
Use the sunvisor to shield direct light through the front or side windows. To
use a sunvisor, pull it downward. To use a sunvisor for a side window, pull it downward,
unsnap it from the br ...
Cruise Control Switch. Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
...