Hyundai Sonata: Oil Cooler. Repair procedures
Removal
1. |
Loosen the drain plug, and drain the coolant. Remove
the radiator cap to speed draining.
|
2. |
Disconnect the oil cooler coolant hoses (A).
|
3. |
Remove the oil filter (A).
|
4. |
Loosen the mounting bolt (A) and remove the oil cooler
assembly (B).
|
Installation
1. |
Apply a light coat of engine oil to the oil cooler
packing surface (A), and then install the oil cooler with fix bolt (B).
|
2. |
Apply a light coat of engine oil to the oil filter
packing surface (A), and then install the oil filter.
|
3. |
Connect the oil cooler coolant hoses (B).
|
4. |
Fill the radiator with coolant and check for leaks.
|
Balance Shaft & Oil Pump. Repair procedures
Removal 1. Remove the timing chain. (Refer to Timing system in this group) 2. Install a stopper pin (A) after compressing the balance ...Oil Pressure Switch. Repair procedures
Inspection 1. Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch. ...See also:
Fuel Tank. Repair procedures
Removal
1.
Release the residual pressure in fuel line (Refer to “Release
Residual Pressure in Fuel Line” in this group).
2.
Remove the ...
Telemetics Unit (TMU). Repair procedures
Removal
1.
Remove the audio monitor (or AVN head unit) after loosening the
mounting screws.
(Refer to the BE group - "Audio Unit" or "AVN Unit" ...
Impact sensing door unlock system (if equipped)
All doors will be automatically unlocked when the impact is delivered to impact
sensors while the ignition switch is ON. However, the doors may not be unlocked
if mechanical problems occur with th ...