Hyundai Sonata: Oil Pressure Switch. Repair procedures
Inspection
1. |
Check the continuity between the terminal and the
body with an ohmmeter.
If there is no continuity, replace the oil pressure
switch.
|
2. |
Check the continuity between the terminal and the
body when the fine wire is pushed. If there is continuity even when
the fine wire is pushed, replace the switch.
|
3. |
If there is no continuity when a 50kPa (0.50kgf/cm²,
7.25psi) is applied through the oil hole, the switch is operaing properly.
Check for air leakage. If air leaks, the diaphragm
is broken. Replace it.
|
Oil Cooler. Repair procedures
Removal 1. Loosen the drain plug, and drain the coolant. Remove the radiator cap to speed draining. 2. Disconnect the oil cooler coolant h ...See also:
Engine compartment fuse replacement
1. Turn the ignition switch and all other switches off.
2. Remove the fuse panel cover by pressing the tab and pulling up.
3. Check the removed fuse; replace it if it is blown. To remove or inse ...
Multimedia jack. Schematic Diagrams
Circuit Diagram
...
Camshaft Position Sensor (CMPS). Troubleshooting
Wave Form
...