Hyundai Sonata: Output Speed Sensor. Repair procedures
Removal
1. |
Remove the battery and the battery tray. (Refer to
"Charging system" in EE group.)
|
2. |
Remove the under cover (A).
|
3. |
Replace new gasket and the plug after drining the
automatic transaxle fluid by removing the drain plug.
(Refer to "Automatic transaxle system" in this group.)
|
4. |
Remove the valve body cover (A) and eyebolt (B).
|
5. |
Remove the plate and the detend spring (A) after
removing the bolt.
|
6. |
Remove the bolt (3ea) after disconnecting the solenoid
valve connector (A) and the oil temperature sensor connector (B).
|
7. |
Remove the valve body assembly (A).
|
8. |
Disconnect the input & output speed sensor connector
(A).
|
9. |
Remove the input & output speed sensor (B) after
removing the bolts(2ea).
|
Installation
1. |
Installation is the reverse of removal.
|
After replacement or reinstallation procedure of
the valve body assembly, must perform procedures below.
|
Output Speed Sensor. Specifications
Specification Item Specification Type Hall Effect Sensor, 2pins (Power: 9V, Signal) Operation condition -40 ...Transaxle Oil Temperature Sensor. Specifications
Specification Item Specification Type Negative Thermal Coefficient Type Operation temperature -40~165°C [-40~329°F] ...See also:
Flex Steer. Schematic Diagrams
Schematic Diagrams
...
Input Speed Sensor. Repair procedures
Removal
1.
Remove the battery and the battery tray. (Refer to
"Charging system" in EE group.)
2.
Remove the under cover (A).
...
Smooth cornering
Avoid braking or gear changing in corners, especially when roads are wet. Ideally,
corners should always be taken under gentle acceleration. If you follow these suggestions,
tire wear will be ...