Inspection
1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the PCSV connector.
|
3. |
Measure resistance between the PCSV terminals 1 and 2.
|
4. |
Check that the resistance is within the specification.
Specification:
Refer to “Specification”
|
|
Removal
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the purge control solenoid valve connector (A).
|
3. |
Disconnect the vapor hoses (B) from the purge control solenoid
valve.
|
4. |
Remove the valve from the bracket (C) in the direction of the
arrow.
|
Installation
•
|
Install the component with the specified torques.
|
•
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
•
|
Use care to keep foreign material out of the valve.
|
|
1. |
Installation is reverse of removal.
Purge control solenoid valve
bracket installation bolt: 9.8 ~ 11.8 N.m (1.0
~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
Description
Continuous Variable Valve Timing (CVVT) system advances or retards the
valve timing of the intake and exhaust valve in accordance with the ECM control
signal which is calculated ...
See also:
Armed stage
Using the smart key
Park the vehicle and stop the engine. Arm the system as described below.
1.Turn off the engine.
2.Make sure that all doors, the engine hood and trunk lid are closed and latched. ...
Rear Body. Body Repair
...
Indicator symbols on the instrument cluster
Seat belt warning light
High beam indicator
Turn signal indicator
ESC indicator (ESC malfunction
indicator)
ESC OFF indicator
ABS warning light
Parking brake & Brake fluid warning
...