Hyundai Sonata: Rear Stabilizer Bar. Repair procedures
Replacement
1. |
Remove the rear wheel & tire.
|
2. |
Loosen the nut and then remove the rear stabilizer link (B) with
the rear lower arm (A).
|
3. |
Loosen the nut and then remove the stabilizer link (A) with the
rear stabilizer bar.
|
4. |
Loosen the mounting bolt and then remove the stabilizer bar (B)
with the sub frame (A).
|
5. |
Installation is the reverse of removal.
|
Inspection
1. |
Check the rear stabilizer bar for deformation.
|
2. |
Check the rear stabilizer link ball joint for damage.
|
Rear Lower Arm. Repair procedures
Removal 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...Rear Assist Arm. Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...See also:
Components and Components Location
Component Location
1. Sunroof
2. Sunroof switch
3. Sunroof motor & controller
...
Coolant. Repair procedures
Refilling And Bleeding
Never remove the radiator cap when the engine is
hot. Serious scalding could be caused by hot fluid und ...
Schematic Diagrams
Circuit Diagram
...