Hyundai Sonata: Rear Wheel Speed Sensor. Repair procedures
Removal
1. |
Remove the rear wheel and tire.
|
2. |
Remove the rear wheel speed sensor mounting bolt (A).
|
3. |
Remove the rear seat back. (Refer to the Body group - Seat)
|
4. |
Disconnect the rear wheel speed sensor connector.
|
5. |
Installation is the reverse of removal.
|
Inspection
1. |
Measure the output voltage between the terminal of the wheel speed
sensor and the body ground.
|
2. |
Compare the change of the output voltage of the wheel speed sensor
to the normal change of the output voltage as shown below.
|
Rear Wheel Speed Sensor. Components and Components Location
Components 1. Rear wheel speed sensor cable 2. Rear wheel speed sensor ...Yaw-rate and Lateral G Sensor. Description and Operation
Description When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electroniclly by the vibration change of plate fork inside the yaw rate senso ...See also:
Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below ...
Injector. Specifications
Specification
Item
Specification
Coil Resistance (Ω)
1.18 ~ 1.31 [20°C(68°F)]
...
Heated Oxygen Sensor (HO2S). Specifications
Specification
HO2S [Bank 1/Sensor 1]
Item
Specification
Heater Resistance (Ω)
2.5 ~ 4.0 [20°C(68°F)]
HO2S [Bank 1/Sensor 2 ...