Hyundai Sonata: Relay Box (Engine Compartment). Repair procedures - Fuses And Relays - Body Electrical SystemHyundai Sonata: Relay Box (Engine Compartment). Repair procedures

Hyundai Sonata YF 2011-2014 Service Manual / Body Electrical System / Fuses And Relays / Relay Box (Engine Compartment). Repair procedures

Inspection

Power Relay Test (Type A)
-
Do not use pliers.
-
Pliers will damage the relays, which could cause the engine to stall or not start.
-
Carefully remove the relay using the relay puller.
Check for continuity between the terminals.
A. Front deicer
B. Back up lamp relay
C. IGN2
D. Start #1 relay (H1)
E. HAC relay
F. IGN1
G. Start #2 relay
 H. Cooling fan (HI) relay
I. Cooling fan (LO) relay
J. Blower relay
K. Rear defogger
L. Horn relay
M. ACC
N. Fuel pump relay

1.
There should be continuity between the No.30 and No.87 terminals when power and ground are connected to the No.85 and No.86 terminals.
2.
There should be no continuity between the No.30 and No.87 terminals when power is disconnected.
Power Relay Test (Type C)
Check for continuity between the terminals.
A : Main relay
1.
There should be continuity between the No.30, 87a and No.87 terminals when power and ground are connected to the No.85 and No.86 terminals.
2.
There should be no continuity between the No.30, 87a and No.87 terminals when power is disconnected.
Power Relay Test (Type B)
Check for continuity between the terminals.
A : Rain sensor relay
B : Wiper relay
1.
There should be continuity between the No.30 and No.87 terminals when power and ground are connected to the No.85 and No.86 terminals.
2.
There should be continuity between the No.30 and No.87 terminals when power is disconnected.
Fuse Inspection
1.
Be sure there is no play in the fuse holders, and that the fuses are held securely.
2.
Are the fuse capacities for each circuit correct?
3.
Are there any blown fuses?
If a fuse is to be replaced, be sure to use a new fuse of the same capacity. Always determine why the fuse blew first and completely eliminate the problem before installing a new fuse.
Multi Fuse
Multi Fuse is for optimizing the engine room package.

-
Multi fuse is needed to replace entirely when there is damage to only one fuse.
-
When replace the multi fuse, refer to the "Engine compartment - component location" diagram exactly.
-
Use the multi fuse capacities for each circuit correctly.

    Relay Box (Engine Compartment). Description and Operation
    Description Network Configuration The Network of the SJB(Smart Junction Box) consists of Low speed CAN as shown in the following figure. Termination Resistor The SJB has CAN ter ...

    See also:

    TPMS Sensor. Description and Operation
    Description 1. Mode (1) Configuration State A. All sensors should be in the Low Line (Base ...

    Checking the coolant level
    WARNING Removing radiator cap Never attempt to remove the radiator cap while the engine is operating or hot. Doing so might lead to cooling system and engine damage and could result in se ...

    Tire rotation
    To equalize tread wear, it is recommended that the tires be rotated every 7,500 miles (12,000 km) or sooner if irregular wear develops. During rotation, check the tires for correct balance. When r ...