Hyundai Sonata: Repair procedures
Service Adjustment Procedure
1. |
Park the vehicle on a level ground and stop the engine.
|
2. |
Remove the oil filler plug and washer. Inspect the manual transaxle
fluid condition and quantity.
|
3. |
If the manual transaxle fluid is contaminated, drain it out by
removing the oil drain plug.
|
4. |
Tighten the new oil drain plug(A) and fill manual transaxle fluid
to a proper level.
|
5. |
Retighten the oil filler plug(B) with a new washer.
|
1. |
Disconnect the back up lamp switch connector (A).
|
2. |
Inspect the continuity of the switch. When the shift lever is
in reverse range, it should have continuity.
|
3. |
Replace the back up lamp switch, if necessary.
|
Manual Transaxle. Components and Components Location
Components 1. Transaxle case 2. Taper roller bearing outer race 3. 1st/2nd shift fork 4. Reverse shift fork 5. Shift rail 6. 3rd/4th shift fork 7. 5th/6th ...See also:
Intake Manifold. Components and Components Location
Components
1. Intake manifold assembly
2. Electronic throttle body
3. Intake manifold stay
4. Intake manifold gasket
...
Battery. Repair procedures
Removal and Installation
1.
Disconnect the terminals from the battery.
Tightening torque :
(+) terminal (A) : 7.8 ~ 9.8N.m (0.8 ~ 1.0kgf. ...
Input Speed Sensor. Description and Operation
Description
- Integrated one unit for input & output speed sensor
- Differential current type (low: 7mA, high: 14mA)
- Failsafe: 4th gear hold (D), 2nd ~ 4th manual shift (S)
...