Hyundai Sonata: Repair procedures
Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground
the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace
it.
Horn Relay Inspection
1. |
Remove the horn relay (A) from the engine room relay box.
|
2. |
There should be continuity between the No.30 and No.87 terminals
when power and ground are connected to the No.85 and No.86 terminals.
|
3. |
There should be no continuity between the No.30 and No.87 terminals
when power is disconnected.
|
Removal
1. |
Remove the front bumper.
(Refer to the BD group - "Front bumper")
|
2. |
Remove the mounting nut and disconnect the horn connector (B),
then remove the horn (A).
|
Installation
1. |
Connect the horn connector, then reassemble the horn.
|
2. |
Reassemble the front bumper.
|
Adjustment
Operate the horn, and adjust the tone to a suitable level by turning the
adjusting screw.
After adjustment, apply a small amount of paint around the screw
head to keep it from loosening.
|
Components and Components Location
Component Location 1. Horn switch 2. Horn relay (Engine room compartment) 3. Horn 4. Clock spring ...AVN System
...See also:
Rear view camera
WARNING
This system is a supplementary function only. It is the responsibility of
the driver to always check the inside/outside rearview mirror and the area behind
the vehicle before ...
Driver Airbag (DAB) Module and Clock Spring. Components and Components Location
Components
1. Driver Airbag (DAB)
2. Steering Wheel
3. Clock Spring
...
Water pump. Repair procedures
Removal and Installation
1.
Loosen the drain plug, and then drain the engine
coolant. Remove the radiator cap to drain with speed.
2.
Remo ...