Hyundai Sonata: Repair procedures
On-vehicle Inspection
|
Check The Battery Terminals And Fuses
1. |
Check that the battery terminals are not loose or corroded.
|
2. |
Check the fuses for continuity.
|
Inspect Drive Belt
Visually check the belt for excessive wear, frayed cords etc.
If any defect has been found, replace the drive belt.
Cracks on the rib side of a belt are considered acceptable. If
the belt has chunks missing from the ribs, it should be replaced.
|
Visually Check Alternator Wiring And Listen For Abnormal Noises
1. |
Check that the wiring is in good condition.
|
2. |
Check that there is no abnormal noise from the alternator while
the engine is running.
|
Check Discharge Warning Light Circuit
1. |
Warm up the engine and then turn it off.
|
2. |
Turn off all accessories.
|
3. |
Turn the ignition switch "ON". Check that the discharge warning
light is lit.
|
4. |
Start the engine and Check that the light goes off.
If the light does not go off as specified, troubleshoot the discharge
light circuit.
|
Description and Operation
Description The charging system includes a battery, an alternator with a built-in regulator, and the charging indicator light and wire. The Alternator has built-in diodes, each rectifying A ...Alternator. Components and Components Location
Components 1. Pulley 2. Front bracket 3. Front bearing 4. Bearing cover 5. Bearing cover bolt 6. Rotor 7. Rear bearing 8. Rear bracket 9. Through b ...See also:
Seat Belt Buckle Switch (BS). Components and Components Location
Components
...
Alternator. Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal first, then the positive
terminal.
Tightening torque :
(+) term ...
Camshaft Position Sensor (CMPS). Description and Operation
Description
Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft
position by using a hall element.
It is related with Crankshaft Position Sensor (CKPS) and detects the ...