Hyundai Sonata: Seat Belt Buckle Switch (BS). Description and Operation
Description
The SRSCM shall monitor the status of the driver and front passenger seat
belt buckle. The SRSCM provides one pin each for the driver and front passenger
seat belt buckle status input. The seat belt buckle circuit operates from internal
boost voltage supplied by the SRSCM, and uses chassis ground for the signal
return. The buckle status shall modify the SRSCM deployment. If the buckle status
is unbuckled, the corresponding pretensioner will not be deactivated.
Seat Track Position Sensor (STPS). Repair procedures
Removal
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the front seat asse ...
See also:
Balance Shaft & Oil Pump. Repair procedures
Removal
1.
Remove the timing chain.
(Refer to Timing system in this group)
2.
Install a stopper pin (A) after compressing the balance
...
Rear Lower Arm. Repair procedures
Removal
1.
Remove the rear wheel & tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...
Special Service Tools
Special Service Tools
Tool(Number and Name)
Illustration
Use
09581-11000
Piston expander
Spreading the front and r ...
