Hyundai Sonata: Seat Track Position Sensor (STPS). Repair procedures - SRSCM - RestraintHyundai Sonata: Seat Track Position Sensor (STPS). Repair procedures

Hyundai Sonata YF 2011-2014 Service Manual / Restraint / SRSCM / Seat Track Position Sensor (STPS). Repair procedures

Removal

1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front seat assembly. (Refer to BD group)
3.
Loosen the two STPS screws, then remove the STPS after disconnecting the STPS connector.

Installation

Be sure to install the harness wires so they will not pinch or interfere with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3.
Install the STPS with two screws.
4.
Install the front seat assembly. (Refer to BD group)
5.
Reconnect the battery negative cable.
6.
After installing the Seat Track Position Sensor, confirm proper system operation:
Turn the ignition switch ON, the SRS indicator should be turned on for about six seconds and then go off.

    Seat Belt Buckle Switch (BS). Description and Operation
    Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status ...

    See also:

    Fuel Tank Pressure Sensor (FTPS). Description and Operation
    Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge ...

    Rear Wheel Speed Sensor. Components and Components Location
    Components 1. Rear wheel speed sensor cable 2. Rear wheel speed sensor ...

    Components and Components Location
    Components 1. Piston ring 2. Piston 3. Connecting rod 4. Connecting rod upper bearing 5. Piston pin 6. Connecting rod lower bearing 7. Connecting rod bea ...