Hyundai Sonata: Side Airbag (SAB) Module. Repair procedures - Airbag Module - RestraintHyundai Sonata: Side Airbag (SAB) Module. Repair procedures

Hyundai Sonata YF 2011-2014 Service Manual / Restraint / Airbag Module / Side Airbag (SAB) Module. Repair procedures

Removal

The side airbag cannot be disassembled from the seat back assembly, so replace the seat back assembly when replacing the side airbag.
1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the front seat assembly. (Refer to the Body group- Seat)
3.
Remove the seat back assembly. (Refer to the Body group- Seat)

Installation

Be sure to install the harness wires so they will not pinch or interfere with other parts.
•
Do not open the lid of the side airbag cover.
•
Make sure that the airbag assembly cover is installed properly. Improper installation may prevent the proper deployment.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Install the new seat back assembly.
(Refer to the Body group - Seat)
4.
Install the front seat assembly.
(Refer to the Body group - Seat)
5.
Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfere with other parts.
6.
Reconnect the battery negative cable.
7.
After installing the side airbag (SAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

    Curtain Airbag (CAB) Module. Description and Operation
    Description Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of curtain ...

    See also:

    Compass function
    The Compass can be turned ON and OFF and will remember the last state when the ignition is cycled. To turn the display feature ON/OFF: 1. Press and release the button within 1 second to turn the di ...

    Troubleshooting
    Troubleshooting Symptom Possible cause Remedy Speedometer does not operate Fuse (MODULE1 7.5A and Room lamp 10A) in smart junction box ...

    Room Lamp. Repair procedures
    Inspection Room Lamp 1. Check that the switch operates properly after disconnecting the room lamp connector (A). Removal Room L ...