Hyundai Sonata: Solenoid valve. Repair procedures
Removal
1. |
Remove the battery and the battery tray. (Refer to
"Charging system" in EE group.)
|
2. |
Remove the under cover (A).
|
3. |
Replace new gasket and the plug after drining the
automatic transaxle fluid by removing the drain plug.
(Refer to "Automatic transaxle system" in this group.)
|
4. |
Remove the valve body cover (A) and eyebolt (B).
|
5. |
Remove the bolt (3ea) after disconnecting the solenoid
valve connector (B) and the oil temperature sensor connector (A).
|
6. |
Remove the solenoid valve (A) after removing the
solenoid support.
|
Installation
1. |
Installation is the reverse of removal.
|
After replacement or reinstallation procedure of
the valve body assembly, must perform procedures below.
|
Solenoid valve. Specifications
Specification Item Function Piece Specification VFS 26/B T/Con 2 Control p ...See also:
Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wi ...
In case of an emergency while driving
If the engine stalls at a crossroad or crossing
If the engine stalls at a crossroad or crossing, set the shift lever in the N
(Neutral) position and then push the vehicle to a safe place.
If you h ...
Specifications
Specifications
Item
Specification
Transmission type
A6MF2
Engine model
Gasoline 2.4 GDI
Torque conve ...