Hyundai Sonata: Specifications
Specifications
|
Item |
Specification |
|
|
Clutch operation method |
Hydraulic type |
|
|
Clutch cover assembly |
Type |
Diaphragm spring strap |
|
Clutch disc |
Type |
Single dry with diaphragm |
|
Facing diameter (outside x inside) |
Ø240 × Ø155mm (Ø9.4488 × Ø6.1024in.) |
|
|
Concentric slave cylinder |
Cylinder diameter (inside x outside) |
Ø32.2 x Ø44mm (Ø1.2677 × Ø1.7323in.) |
Service Standard
|
Item |
Specification |
|
Clutch disc thickness [When free] |
8.7 (-0.3~+0.25mm) [0.3425 (-0.0118~+0.098in.)] |
|
Clutch pedal height |
216 mm (8.5039 in.) |
|
Clutch pedal free play |
6 ~ 13 mm (0.2362 ~ 0.5118 in.) |
|
Clutch pedal stroke |
145 ± 3mm (5.7087 ± 0.1181 in.) |
|
Clutch disc rivet depth |
1.3 mm Min. (0.0512 in. Min.) |
|
Diaphragm spring end height difference |
0.5 mm (0.0197 in.) |
|
Clutch master cylinder clearance to piston |
1.6 mm (0.0630 in.) |
Tightening Torques
|
Item |
N.m |
kgf.m |
lb-ft |
|
Clutch cover asssembly |
24.5~34.3 |
2.5~3.6 |
18.1~26.0 |
|
Ignition lock switch |
7.8~9.8 |
0.8~1.0 |
5.8~7.2 |
|
Clutch pedal and pedal mounting bolt |
9.8~14.7 |
1.0~1.5 |
7.2~10.8 |
Lubricants
|
Item |
Specified lubricants |
Quantity |
|
Input spline |
CASMOLY L9508 |
0.2g |
|
Concentric slave cylinder assembly |
KLUBER 9R100 |
As required |
|
Clutch pedal shaft and bushings |
Chassis grease SAE J310, NGLI NO.1 |
Special Service Tools
Special Service Tools
Tools
(Number and Name)
Illustration
Use
09411-1P000
Clutch disc guide
Installation of the ...
See also:
Hazard warning flasher
The hazard warning flasher should be used whenever you find it necessary to stop
the car in a hazardous location. When you must make such an emergency stop, always
pull off the road as far as ...
AVN Head Unit. Repair procedures
Removal
AVN Head Unit
•
Take care not to scratch the center fascia panel and related
par ...
Troubleshooting
Trouble Shooting
Ignition System
Symptom
Suspect area
Remedy
Engine will not start or is hard to start (Cranks OK)
Ignition lock switc ...
