Hyundai Sonata: Starter Relay. Repair procedures
Inspection
| 1. |
Remove the fuse box cover.
|
| 2. |
Remove the starter relay (A).
|
| 3. |
Using an ohmmeter, check that there is continuity between each
terminal.
|
| 4. |
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87.
|
| 5. |
If there is no continuity, replace the starter relay.
|
| 6. |
Install the starter relay.
|
| 7. |
Install the fuse box cover.
|
Starter. Repair procedures
Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal (A).
Tightening tor ...
See also:
How vehicle audio works
AM and FM radio signals are broadcast from transmitter towers located around
your city. They are intercepted by the radio antenna on your vehicle. This signal
is then received by the radio and s ...
Front Driveshaft. Repair procedures - Revised
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and ...
To resume cruising speed at more than approximately 25 mph (40 km/h)
If any method other than the cruise ON/OFF switch was used to cancel cruising
speed and the system is still activated, the most recent set speed will automatically
resume when the RES+ switch ...
