Hyundai Sonata: Steering Angle Sensor. Description and Operation - ESC(Electronic Stability Control) System - Brake SystemHyundai Sonata: Steering Angle Sensor. Description and Operation

Description

The Steering Angle Sensor (SAS) is installed in EPS (Electric Power Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning direction and speed of the steering wheel.
The HECU uses the signals from the SAS when performing ESP-related calculations.
Components (Steering Angle Sensor, Torque Sensor, Failsafe relay, etc.) of the EPS system are located inside the steering column & EPS unit assembly and the steering column & EPS unit assembly must not be disassemble to inspect or replace them. (Refer to “ST (Steering system) Gr.”)

    ESC OFF Switch. Repair procedures
    Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad side switch assembly. ...

    See also:

    Engine Coolant Temperature Sensor (ECTS). Schematic Diagrams
    Circuit Diagram ...

    Components and Components Location
    Component Location 1. Start Stop Button(SSB) 2. FOB key holder 3. FOB key 4. PDM(Power Distribution Module) 5. Smart key unit 6. RF receiver 7. Body control modul ...

    Troubleshooting
    Failure Diagnosis 1. In principle, ESC and TCS controls are prohibited in case of ABS failure. 2. When ESC or TCS fails, only the failed s ...