Hyundai Sonata: Sunroof Motor. Repair procedures
Inspection
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the overhead console and roof trim.
(Refer to the BD group - "Roof trim")
|
3. |
Remove the sunroof motor after removing the screws and connector
(10P).
|
4. |
Ground the terminals as below table, and check that the sunroof
unit operates as below table.
|
5. |
Make these input tests at the connector
If any test indicates a problem, find and correct the cause, then
recheck the system.
If all the input tests prove OK, the sunroof motor must be faulty;
replace it.
|
1. |
Turn the ignition key to the ON position.
|
2. |
According to the position of the sunroof, do as follows.
|
3. |
Release the TILT button.
|
4. |
Press and hold the TILT button once again until the sunroof has
returned to the original position of TILT after it is raised a little
higher than the maximum TILT position.
When this is complete, the sunroof system is reset.
|
1. |
The Sunroof ECU detects the Run- time of motor
|
2. |
Motor can be operated continuously for the 1st run-time(120 ±
10sec.).
|
3. |
The continuous operation of motor stops after the 1st Run-time(120
± 10sec.).
|
4. |
Then Motor is not operated for the 1st Cool-time(18 ± 2sec.).
|
5. |
Motor is operated for the 2nd Run-time(10 ± 2sec.) at the continued
motor operation after 1st Cool-time(18 ± 2sec.)
|
6. |
The continuous operation of motor stops operating after the 2nd
Run-time(10 ± 2sec.)
|
7. |
Motor is not operated for the 2nd Cool-time(18 ± 2sec.).
|
8. |
Motor repeats the 2nd run-time and 2nd cool-time at the continued
motor operation.
T1 : 120 ± 10 sec., T2 : 18 ± 2 sec.,
T3 : 10 ± 2 sec., T4 : 18 ± 2 sec.
|
Sunroof Switch. Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Open the sunglass case cover from the overhead console then remove the 2 sc ...Lighting System
...See also:
Smart key unit. Components and Components Location
Component (1)
Connector Pin Information
Pin
Connector A
Pin
Connector B
1
Battery
1
Interior 2 an ...
Intake Manifold. Repair procedures
Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal (A).
Tightening tor ...
Battery saver function
The purpose of this feature is to prevent the battery from being discharged.
The system automatically turns off the parking lights when the driver removes
the ignition key (smart key : turns ...