Hyundai Sonata: Sunroof. Repair procedures
Replacement
|
1. |
Remove the glass (A) by lifting it up.
|
2. |
Installation is the reverse of removal.
|
1. |
Remove the over head console.
|
2. |
Disconnect the motor connector (A), remove the screws and then
remove the motor (B).
|
3. |
Installation is the reverse of removal.
|
1. |
Open the glass fully.
|
2. |
Disconnect the deflector link (A) from the frame (B), and then
remove the deflector (C).
|
3. |
Installation is the reverse of removal.
|
1. |
Remove the follows parts.
|
2. |
Disconnect the drain tubes (A).
|
3. |
After loosening the mounding bolts and nuts, remove the sunroof
assembly (B).
|
4. |
Installation is the reverse of removal.
|
1. |
Remove the sunroof assembly.
|
2. |
Remove the drip link (A) and sunshade stopper (B).
|
3. |
Remove the sunshade (C) and drip rail (D).
|
4. |
Installation is the reverse of removal.
|
1. |
Remove the sunroof assembly.
|
2. |
Remove a guide assembly (A) after lowering a guide thoroughly
by pushing a slide to rear.
|
3. |
Remove the guide (A) and slide (B).
|
4. |
Installation is the reverse of removal.
|
Adjustment
1. |
Check that the glass has been installed.
|
2. |
Push the down switch. (Keep on pushing the switch)
|
3. |
After moving the slide 5mm forward, turn OFF the switch and push
the down switch (Keeping on pushing the switch with continuous operation).
|
4. |
When the sunroof is closed completely, turn OFF the down switch
initialize the motor completely.
|
1. |
First operation in the vehicle after manufacture it.
|
2. |
Initial value is erased or damaged because of short power electric
discharge during operation.
|
3. |
After using the manual (emergency) handle.
|
Sunroof. Components and Components Location
Components 1. Glass panel assembly 2. Drip link 3. Guide assembly 4. Sunshade assembly 5. Drip rail 6. Deflector 7. Deflector link assembly 8. Sunroof ...Panoramaroof. Components and Components Location
Components 1. Roof molding 2. Movable glass 3. Wind deflector 4. Front cover assembly 5. Roller blind 6. Mechanism assembly 7. Motor 8. Cover ...See also:
Sunshade
The sunshade will be opened with the glass panel automatically when the glass
panel is slid.You will have to close it manually if you want it closed.
CAUTION
The sunroof is made to slide toget ...
High Pressure Fuel Pump. Repair procedures
Removal
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be in ...
License plate light bulb replacement
1. Loosen the retaining screws with a philips head screwdriver.
2. Remove the soket by turning it connterclockwise.
3. Remove the bulb by pulling it straight out.
4. Install a new bulb.
5. Rei ...