Hyundai Sonata: Temperature control - Manual heating and air conditioning - Automatic climate control system - Features of your vehicleHyundai Sonata: Temperature control

Type A

Type A

Type B

Type B

The temperature will increase to the maximum by turning the knob to the right.

The temperature will decrease to the minimum by turning the knob to the left. When turning the knob, the temperature will increase or decrease by 2°F for type A or 1°F for type B.

Type A

Type A

Type B

Type B

Adjusting the driver and passenger side temperature individually

1. Press the DUAL button to operate the driver and passenger side temperature individually. Turning the right temperature control knob will automatically switch to the DUAL mode as well.
2. Turn the left temperature control knob to adjust the driver side temperature. Turn the right temperature control knob to adjust the passenger side temperature.

When the driver side temperature is set to the highest or lowest temperature setting, the DUAL mode is deactivated for maximum heating or cooling.

Adjusting the driver and passenger side temperature equally

1. Press the DUAL button again to deactivate DUAL mode. The passenger side temperature will be set to the same temperature as the driver side temperature.
2. Turn the left temperature control knob. The driver and passenger side temperature will be adjusted equally.

    Mode selection
    Type A The mode selection button controls the direction of the air flow through the ventilation system. The air flow outlet port is converted as follows: Refer to the illustration in the “M ...

    Air intake control
    Type A Type B Adjusting the driver and passenger side temperature individually 1. Press the DUAL button to operate the driver and passenger side temperature individually. Turning the righ ...

    See also:

    Antenna. Repair procedures
    Inspection Glass Antenna Test 1. Wrap aluminum foil (A) around the tip of the tester probe (B) as shown. 2. Touch one tester p ...

    Power Window Relay. Repair procedures
    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the junction box. 3. Check for continuit ...

    Power Out Side Mirror Switch. Repair procedures
    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim panel. (Refer to the BD group - "Front d ...