Hyundai Sonata: Thermostat. Repair procedures
Removal and Installation
Disassembly of the thermostat would have an adverse
effect, causing a lowering of cooling efficiency. Do not remove the
thermostat, even if the engine tends to overheat.
|
1. |
Drain engine coolant so its level is below thermostat.
|
2. |
Disconnect the radiator lower hose (A).
|
3. |
Remove water inlet fitting (C), gasket (B) and thermostat
(A).
|
4. |
Installation is reverse order of removal.
|
5. |
Fill the engine coolant.
|
6. |
Start the engine and check for leaks.
|
7. |
Recheck the coolant level.
|
Inspection
1. |
Immerse the thermostat in water and gradually heat
the water.
|
2. |
Check the valve opening temperature.
If the valve opening temperature is not as specified,
replace the thermostat.
|
3. |
Check the valve lift.
If the valve lift is not as specified, replace the
thermostat.
|
Water pump. Troubleshooting
Troubleshooting Water Pump Symptoms Possible Causes Remedy Coolant leakage • From the bleed hole ...Thermostat. Troubleshooting
Troubleshooting Symptoms Possible Causes Remedy Coolant leakage • From the thermostat gasket ...See also:
Fuel Additives
HYUNDAI recommends that you use good quality gasolines treated with detergent
additives such as TOP TIER Detergent Gasoline, which help prevent deposit formation
in the engine. These gasolines wil ...
Body Side Moldings. Repair procedures
Replacement
Roof Molding Replacement
•
When prying with a flat-tip screwdriver, wrap itwith pro ...
Troubleshooting
Failure Diagnosis
1.
In principle, ESC and TCS controls are prohibited in case of ABS
failure.
2.
When ESC or TCS fails, only the failed s ...