Hyundai Sonata: Thermostat. Troubleshooting - Cooling System - Engine Mechanical SystemHyundai Sonata: Thermostat. Troubleshooting

Troubleshooting

Symptoms
 Possible Causes
 Remedy
Coolant leakage
•
From the thermostat gasket
Check the mounting bolts
•
Check the torque of the mounting bolts
•
Retighten the bolts and check leakage again.
Check the gasket for damage
•
Check gasket or seal for damage
•
Replace gaskets and reuse the thermostat.
Cooled excessively
•
Low heater performance (cool air blows-out)
•
Thermogauge indicates 'LOW'
Visually check after removing the radiator cap.
•
Insufficient coolant or leakage.
•
After refilling coolant, recheck.
GDS check&Starting engine
•
Check DTCs
•
Check the fan motor performance as temperature varies.
•
Check connection of the fan clutch or the fan motor.
※ If the fan clutch is always connected, there will be a noise at idle.
•
Check the engine coolant sensor, wiring and connectors.
•
Check the fan motor, the relay and the connector.
•
Replace the componants.
Remove the thermostat and inspect
•
Check if there are dusts or chips in the thermostat valve.
•
Check adherence of the thermostat.
•
Clean the thermostat valve and reuse the thermostat.
•
Replace the thermostat, if it doesn't work properly.
Heated excessively
•
Engine overheated
•
Thermogauge indicates 'HI'
Visually check after removing the radiator cap.
•
Insufficient coolant or leakage.
※ Be careful when removing a radiator cap of the overheated vehicle.
•
Check air in cooling system.
•
After refilling coolant, recheck.
•
Check the cylinder head gaskets for damage and the tightening torque of the mounting bolts.
GDS check&Starting engine
•
Check DTCs
•
Check the fan motor performance as temperature varies.
•
Check if the fan clutch slips.
•
Check the water pump adherence or impeller damaged.
•
Check the engine coolant sensor, wiring and connectors.
•
Check the fan motor, the relay and the connector.
•
Replace the fan clutch, if it doesn't work properly.
•
Replace the water pump, if it doesn't work properly.
Immerse the thermostat in boiling water and inspection.
•
After removing the thermostat, check it works properly.
※ Check the thermostat opens at the valve opening temperature.
•
Replace the thermostat, if it doesn't work properly.


    Thermostat. Repair procedures
    Removal and Installation Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. ...

    See also:

    Valve Body. Specifications
    Specification Piece 3pcs Spool 20ea Control Full line pressure variable control Torque converter release control ...

    Injector. Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance betwee ...

    Reset items
    Items should be reset after the battery has been discharged or the battery has been disconnected. Auto up/down window (See section 4) Sunroof (See section 4) Trip computer (See section 4) ...