Description
1. |
Mode
(1) |
Virgin State
A. |
The receiver as a sole part is shipped in this
state. Replacement parts should therefore arrive in
this state.
|
B. |
In this state, there is no Auto-Location, no sensor
wake-up, no sensor monitoring and no DTC monitoring..
|
C. |
The state indicates that platform specific parameters
must be written to the receiver and that sensors are
un-learned.
|
|
(2) |
Normal State
A. |
In order for tire inflation state and DTC monitoring
to occur, the receiver must be in this state.
|
B. |
In this state, automatic sensor location is enabled.
|
|
|
2. |
Overview
A. |
Sends LF command data to initiators.
|
B. |
Controls sensor state:
Ignition on - Normal Delayed
Ignition off - Storage.
|
E. |
Receives RF data from sensor.
|
F. |
Uses sensor data to decide whether to turn on TREAD Lamp.
|
G. |
Uses sensor information, distance traveled, background
noise levels, Auto-learn status, short circuit output status,
vehicle battery level, internal receiver states to determine
if there is a system or a vehicle fault.
|
|
Removal
Handle the sensor with care.
1.
Remove the tire. (Refer to "Tire Removal")
...
Circuit Diagram
Connector pin number
Pin NO.
Discription
Remark
1
-
2
-
...
See also:
Outside rearview mirror
Be sure to adjust mirror angles before driving.
Your vehicle is equipped with both lefthand and right-hand outside rearview mirrors.
The mirrors can be adjusted remotely with the remote switch. The ...
Weight Classification System (WCS). Repair procedures
Removal
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the front passenger ...
Turn by Turn
The Turn by Turn feature can be used through Blue Link.
1. Direction Indicator Image
2. Remaining distance until next point
3. The Count bar is divided into a total of 9 levels.
4. Current Str ...