Hyundai Sonata: Variable Intake Solenoid (VIS) Valve. Repair procedures
Inspection
1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the VIS valve connector.
|
3. |
Measure resistance between VIS valve terminals 1 and 2.
|
Removal
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the variable intake solenoid valve connector (A).
|
3. |
Disconnect the vacuum hoses (B,C) from the valve.
|
4. |
Remove the installation bolt (D), and then remove the valve from
the surge tank.
|
Installation
|
|
1. |
Installation is reverse of removal.
|
Variable Intake Solenoid (VIS) Valve. Schematic Diagrams
Circuit Diagram ...Fuel Pressure Control Valve. Description and Operation
Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on ...See also:
Brake Booster. Repair procedures
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
1.
Run the engine for one or two minutes, and then stop ...
Description and Operation
Description
Emissions Control System consists of three major systems.
•
The Crankcase Emission Control System prevents blow-by gas from
releasing into the atmosphere. T ...
Before entering vehicle
Be sure that all windows, outside mirror( s), and outside lights are clean.
Check the condition of the tires.
Check under the vehicle for any sign of leaks.
Be sure there are no obstacles beh ...