Hyundai Sonata: Windshield Deicer Switch. Repair procedures
Inspection
1. |
The windshield deicer switch inputs can be checked using the GDS.
|
2. |
To check the input value of windshield deicer switch, select option
"Body Control Module".
|
3. |
Select option "Current Data of smart junction box".
|
4. |
To check the input value of windshield deicer switch in force
mode, select option "Actuation Test of smart junction box".
|
Removal
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the center fascia panel (A) after loosening the mounting
screws.
|
3. |
Disconnect the heater control unit connector (A) and hose (B).
|
4. |
Remove the heater control unit contained the windshield deicer
switch from the center fascia panel.
|
Installation
1. |
Install the heater control unit.
|
2. |
Install the center fascia panel.
|
3. |
Install the crash pad garnish.
|
Repair procedures
Inspection 1. Remove the cowl top cover. (Refer to the wiper) 2. Disconnect the windshield deicer connector (A) from the wiper motor linka ...See also:
Power Seat Control Switch. Repair procedures
Inspection
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the power seat switch.
A ...
Anchor Pretensioner (APT). Description and Operation
Description
Front seat belt anchor pretensioner operates as well as belt pretensioner
at the same time If it gets into its deploy condition after a collision. It
is located at near anchor on ...
Rear Wheel Speed Sensor. Components and Components Location
Components
1. Rear wheel speed sensor cable
2. Rear wheel speed sensor
...