Hyundai Sonata: Fan speed control
The ignition switch must be in the ON position for fan operation.
The fan speed control knob allows you to control the fan speed of the air flowing from the ventilation system. To change the fan speed, turn the knob to the right for higher speed or left for lower speed. Setting the fan speed control knob to the “0” position turns off the fan.
Air intake control
This is used to select outside (fresh) air position or recirculated air position.
To change the air intake control position, push the control button.
Recirculated air position
The indicator ...
Air conditioning
Press the A/C button to turn the air conditioning system on (indicator light
will illuminate). Press the button again to turn the air conditioning system off. ...
See also:
To defrost outside windshield
1. Set the fan speed to the highest (extreme right) position.
2. Set the temperature to the extreme hot position.
3. Select the position.
4. The outside (fresh) air will be selected automaticall ...
Balance Shaft & Oil Pump. Repair procedures
Removal
1.
Remove the timing chain.
(Refer to Timing system in this group)
2.
Install a stopper pin (A) after compressing the balance
...
Trailing Arm. Repair procedures
Replacement
1.
Remove the rear wheel & tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...
