Hyundai Sonata: Floor mat anchor(s) - Interior features - Features of your vehicleHyundai Sonata: Floor mat anchor(s)

When using a floor mat on the front floor carpet, make sure it attaches to the

When using a floor mat on the front floor carpet, make sure it attaches to the floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward.

WARNING

The following must be observed when installing ANY floor mat to the vehicle.

  • Ensure that the floor mats are securely attached to the vehicle’s floor mat anchor(s) before driving the vehicle.
  • Do not use ANY floor mat that cannot be firmly attached to the vehicle’s floor mat anchors.
  • Do not stack floor mats on top of one another (e.g. all-weather rubber mat on top of a carpeted floor mat). Only a single floor mat should be installed in each position. IMPORTANT – Your vehicle was manufactured with driver’s side floor mat anchors that are designed to securely hold the floor mat in place. To avoid any interference with pedal operation, HYUNDAI recommends that only the HYUNDAI floor mat designed for use in your vehicle be installed.
    Clothes hanger
    To use the hanger, pull down the upper portion of hanger. CAUTION Do not hang heavy clothes, because it may damage the hook. ...

    Aux, USB and iPod® port
    If your vehicle has an aux and/or USB(universal serial bus) port or iPod port, you can use an aux port to connect audio devices and a USB port to plug in a USB, and an iPod port to plug in an ...

    See also:

    Seat Heater Switch Repair procedures
    Removal [Front Seat] 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and A/C control unit. (Refer to Heating, Ventilation and Air Conditioning - "Controller") [Rear ...

    Oil Cooler. Repair procedures
    Removal 1. Loosen the drain plug, and drain the coolant. Remove the radiator cap to speed draining. 2. Disconnect the oil cooler coolant h ...

    Variable Intake Solenoid (VIS) Valve. Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the VIS valve connector. 3. Measure resistance betwe ...