Hyundai Sonata: Fob Holder. Repair procedures - Button Engine Start System - Body Electrical SystemHyundai Sonata: Fob Holder. Repair procedures

Removal

1.
Disconnect the negative(-) battery terminal.
2.
Remove the floor console.
(Refer to the BD group - "Console")
3.
Disconnect the fob holder connector (A).

4.
Remove the fob holder (A) by pushing both sides of the hooks.


Installation

1.
Install the fob holder.
2.
Install the floor console.

    See also:

    Water pump. Components and Components Location
    Components 1. Water pump pulley 2. Water pump 3. Water pump gasket 4. Water pump housing 5. Water pump housing gasket 6. O-ring 7. Water inlet pipe 8. ...

    Seat belt restraint system
    WARNING For maximum restraint system protection, the seat belts must always be used whenever the car is moving. Seat belts are most effective when seatbacks are in the upright position. Chi ...

    Repair procedures
    General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below ...