Hyundai Sonata: Immobilizer Control Unit. Repair procedures
Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
|
| 3. |
Disconnect the 5P connector of the SMARTRA unit and then remove
the SMARTRA unit (A) after loosening the bolt.
|
| 4. |
Installation is the reverse of removal procedure.
|
Repair procedures
Teaching Procedures
1.
Key Teaching Procedure
Key teaching must be done after replacing a defective PCM(ECM)
or when providing additional keys to the vehicle owner ...
Antenna Coil. Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds after loosening
the scr ...
See also:
Components and Components Location
Component Location
1. Fuel filler door open switch
2. Fuel filler door release actuator
...
Audio Remote Control. Repair procedures
Inspection
1.
Check the audio remote control switch for resistance between No.3
and No.5 terminals in each switch position.
Switch
...
ETC (Electronic Throttle Control) System. Troubleshooting
Fail-Safe Mode
Item
Fail-Safe
ETC Motor
Throttle valve stuck at 5°
TPS
TPS 1 fault
ECM looks at TPS2
...

