Components and Components Location

Component Location 1. Power door mirror 2. Power door mirror switch ...

Power Out Side Mirror Switch. Repair procedures

Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim panel. (Refer to the BD group - "Front d ...

See also:

Output Speed Sensor. Specifications
Specification Item Specification Type Hall Effect Sensor,  2pins (Power: 9V, Signal) Operation condition -40 ...

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below ...

Fuel Pressure Control Valve. Schematic Diagrams
Circuit Diagram ...