Hyundai Sonata: Road warning
Hazard warning flasher
The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle.
It should be used whenever emergency repairs are being made or when the vehicle is stopped near the edge of a roadway.
Depress the flasher switch with the ignition switch in any position. The flasher switch is located in the center console switch panel. All turn signal lights will flash simultaneously.
- The hazard warning flasher operates whether your vehicle is running or not.
- The turn signals do not work when the hazard flasher is on.
- Care must be taken when using the hazard warning flasher while the vehicle is being towed.
In case of an emergency while driving
If the engine stalls at a crossroad or crossing
If the engine stalls at a crossroad or crossing, set the shift lever in the N
(Neutral) position and then push the vehicle to a safe place.
If you h ...
See also:
Balance Shaft & Oil Pump. Repair procedures
Removal
1.
Remove the timing chain.
(Refer to Timing system in this group)
2.
Install a stopper pin (A) after compressing the balance
...
Fuel Filler Door Release Actuator. Repair procedures
Inspection
1.
Remove the trunk room left side trim.
(Refer to the BD group - "Interior trim")
2.
Open the fuel filler door an ...
Repair procedures
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS Pro to check for DTCs.
Refer to the Diagnosti ...
