Hyundai Sonata: Transaxle Oil Temperature Sensor. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Sonata: Transaxle Oil Temperature Sensor. Repair procedures

Removal

1.
Remove the battery and the battery tray. (Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
3.
Replace new gasket and the plug after drining the automatic transaxle fluid by removing the drain plug.
(Refer to "Automatic transaxle system" in this group.)
4.
Remove the valve body cover (A) and eyebolt (B).
Tightening torque:
(A) 12.8 ~ 14.7 N.m (1.3 ~ 1.5 kgf.m, 9.4 ~ 10.8 lb-ft)
(B) 34.3 ~ 44.1 N.m (3.5 ~ 4.5 kgf.m, 25.3 ~ 32.6 lb-ft)
The gasket of the eyebolt use new one.
Remove installation bolts in the engin room first and then remove others under the vehicle.

5.
Disconnect the oil temperature sensor connector (A).
6.
Remove the oil temperature sensor (A) after removing a bolt.
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Be careful not to damage the harness lock connector.


Installation

1.
Installation is the reverse of removal.
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
•
Continue to apply liquid gasket at application points at the valve body cover with Ø2.5mm (0.0984in.) thickness.
Liquid gasket Part name :
Threebond 1281B or LOCTITE FMD-546
•
Adding automatic transaxle fluid. (Refer to "automatic transaxle system" in this group.)

    Transaxle Oil Temperature Sensor. Specifications
    Specification Item Specification Type Negative Thermal Coefficient Type Operation temperature -40~165°C [-40~329°F] ...

    Inhibiter Switch. Description and Operation
    Description Item Specification Type Combination of output signals from 4 terminals  Power supply 12V ...

    See also:

    Key operations
    (1) Master key (M) Used to start the engine, lock and unlock the doors, lock and unlock the glove box, and open the trunk. (2) Sub key (S) Used only to start the engine and lock and unlock the do ...

    Smart key unit. Components and Components Location
    Component (1) Connector Pin Information Pin Connector A Pin Connector B 1 Battery 1 Interior 2 an ...

    RADIO : FM, AM OR XM Changing RADIO mode (FM, AM or XM)
    Press the key to change the mode in order of FM1➟FM2➟ AM➟XM1➟XM2➟XM3. When the power is off, press the key to turn on the audio system and receive rad ...