Hyundai Sonata: Digital clock - Interior features - Features of your vehicleHyundai Sonata: Digital clock

WARNING

WARNING

Do not adjust the clock while driving. You may lose your steering control and cause an accident that results in severe personal injury or death.

Средний немецкий танк пантера бумажные only-paper.ru.

Whenever the battery terminals or related fuses are disconnected, you must reset the time.

When the ignition switch is in the ACC or ON position, the clock buttons operate as follows:

Hour (1)

Pressing the H button with your finger, a pencil or similar object will advance the time displayed by one hour.

Minute (2)

Pressing the M button with your finger, a pencil or similar object will advance the time displayed by one minute.

Display conversion

To change the 12 hour format to the 24 hour format, press the “H” and “M” buttons at the same time for more than 3 seconds.

For example, if the “H” and “M” buttons are pressed for more than 3 seconds while the time is 10:15 p.m., the display will be changed to 22:15.

❈ For the type of the clock built in the audio or navigation, refer to a separately supplied manual.

    Power outlet
    The power outlet is designed to provide power for mobile telephones or other devices designed to operate with vehicle electrical systems. The devices should draw less than 10 amps with the engin ...

    Clothes hanger
    To use the hanger, pull down the upper portion of hanger. CAUTION Do not hang heavy clothes, because it may damage the hook. ...

    See also:

    Trunk lid control switch
    The trunk lid control switch is used to prevent unauthorized access to the trunk. When the trunk lid control switch is UNLOCK position (), the trunk can be unlocked with the trunk lid release ...

    Seat belt restraint system
    WARNING For maximum restraint system protection, the seat belts must always be used whenever the car is moving. Seat belts are most effective when seatbacks are in the upright position. Chi ...

    Rail Pressure Sensor (RPS). Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...