Hyundai Sonata: Hazard warning flasher
The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as possible.
The hazard warning lights are turned on by pushing in the hazard switch. This causes all turn signal lights to blink. The hazard warning lights will operate even though the key is not in the ignition switch.
To turn the hazard warning lights off, push the switch a second time.
Rear view camera
WARNING
This system is a supplementary function only. It is the responsibility of
the driver to always check the inside/outside rearview mirror and the area behind
the vehicle before ...
Lighting
...
See also:
Relay Box (Engine Compartment). Components and Components Location
Components
...
TPMS Receiver. Repair procedures
Replacement
When the receiver first arrives for replacement:
1)
It will be in Virgin State.
...
Certification label
The certification label is located on the driver's door sill at the center pillar.
This label shows the maximum allowable weight of the fully loaded vehicle. This
is called the GVWR (Gross ...
