Hyundai Sonata: Overhead Console Lamp. Repair procedures
Inspection
Remove the overhead console lamp assembly then check for continuity between
terminals. If the continuity is not as specified, replace the map lamp switch.


Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Loosen 2 screws holding the overhead console (A).
|
| 3. |
Disconnect the connectors (A) of sunroof switch and lamp switch
then remove the overhead console lamp assembly.
|
| 4. |
If necessary to replace the bulb, replace the bulb after opening
the overhead console lens.
|
Installation
| 1. |
Install the overhead console lamp after connecting the sunroof
switch connector and lamp connector.
|
| 2. |
Install the lens after tightening 2 screws.
|
Overhead Console Lamp. Schematic Diagrams
Circuit Diagram
...
License Lamp. Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the lens (A) after loosening the mounting screws.
...
See also:
Engine number
2.4 engine
2.0 engine
The engine number is stamped on the engine block as shown in the drawing. ...
Display settings
Press the key - Select [Display]
through TUNE knob or
key Select menu through
TUNE knob
Mode Pop up
[Mode Pop up] - Changes /
selection mode
• During On state, press the or
key ...
Air bag warning light
The purpose of air bag warning light in your instrument panel is to alert you
of a potential problem with your air bag - Supplemental Restraint System (SRS).
When the ignition switch is turned ON ...


