Hyundai Sonata: Power windows - Windows - Features of your vehicleHyundai Sonata: Power windows

The ignition switch must be in the ON position for power windows to operate. Each door has a power window switch that controls the door's window. The driver has a power window lock switch which can block the operation of passenger windows. The driver’s door has a master power window switch that controls all the windows in the vehicle. The power windows can be operated for approximately 30 seconds after the ignition key is removed or turned to the ACC or LOCK position. However, if the front doors open, the power windows cannot be operated within the 30 second period after ignition key removal.

Насосы вакуумные роторные купить пластинчато роторный вакуумный насос купить.

✽ NOTICE

While driving with the rear windows down or with the sunroof (if equipped) in an open (or partially open) position, your vehicle may demonstrate a wind buffeting or pulsation noise. This noise is a normal occurrence and can be reduced or eliminated by taking the following actions. If the noise occurs with one or both of the rear windows down, partially lower both front windows approximately one inch. If you experience the noise with the sunroof open, slightly reduce the size of the sunroof opening.

Windows
(1) Driver’s door power window switch (2) Front passenger’s door power window switch (3) Rear door (left) power window switch (4) Rear door (right) power window switch (5) Window opening and ...

Window opening and closing
To open or close a window, press down or pull up the front portion of the corresponding switch to the first detent position (5). ...

See also:

Steering Angle Sensor. Description and Operation
Description The Steering Angle Sensor (SAS) is installed in EPS (Electric Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning ...

Repair procedures - Revised
Fuel Pressure Test 1. Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group). ...

ESC Control Module. Repair procedures
Removal 1. Turn the ignition switch OFF. 2. Remove the air cleaner assembly (A). 3. Pull up the lock o ...